39
38
Step 4
: turn and pull the handle to open the door.
Step 5
: turn the key counterclockwise 180 degree and pull off
4. Installation of the lock
4.1 Checking before installation
You will need - Hole cutter (30 ~ 35mm)
- Electric drill (10mm drill bit)
- Screwdriver
Door Thickness must between 38 ~ 60mm
Checked for right or left handed positioning
Left Hand/Right Hand
4.2 Installation Template
This product can be used for either left or right handed doors.
5. Maintenance
- This is a high-tech electronic device. It is highly recommended that all repairs
are done by authorised persons only. Failure to comply could void your
warranty.
- Keep the sensor surface clean and dry. Wipe gently with a clean, soft, dry
cloth to remove any dirt, residues, stains or moisture.
- A low battery warning alarm will sound when the batteries run down to less
than 30% of full power. You should then replace all of the batteries with a new
set as soon as possible.
- If you do not change the batteries in time, or mix old and new batteries
causing rapid power loss, and the lock ceases to function, then you can place
a 9V square battery on the terminals at the base of the front body to provide
temporary power. Your fingerprint records are not lost. You can enter using
an enrolled fingerprint and then change the batteries.
- The batteries supplied with the lock may suffer some power loss during
storage and transit prior to sale and will be subject to heavy use during initial
testing and enrolment. They may need to be replaced sooner than normally
expected.