Curtiss-Wright R-NET OMNI2, Техническое руководство, Страница: 35 / 164

Curtiss-Wright | PG Drives Technology
SK81935-01
R-net Omni2 Technical Manual | Chapter 2 – Operation | 35
If the R-net system is configured for latched operation in reverse as well as forwards, the scan sequence will change when
driving in reverse to:
Reverse, Right, Forward, Left, Forward, Right, Forward, Left, Forward, Right, Reverse.
7.2 SEATING CONTROL
Seating Mode can be entered from the User Menu via an operation of the User Switch. The Omni2 will sequentially scan
though each available actuator ‘axis’ and then finish with an ‘Exit’ option to return to Drive, the User Menu or the next
sequential function. If the User Switch is operated when one of the actuator axes are shown, a new scanning sequence will
begin. The Omni2 will step through, ‘up’, ‘down’ and ‘exit’ choices. Each option can then be selected with an operation of the
User Switch.
The scanning rate of the actuator axes is set to approximately 1 second and cannot be altered through programming.
7.3 ASSOCIATED PROGRAMMING
It is possible to set up the Omni2 so that the functions can be navigated audibly. This can be useful if the user cannot always
easily see the Omni2’s screen. Refer to the Using the Omni2 by Sound section in the Advanced Programming chapter for
further details.
NOTE (HP, IN)
It is not advisable to program the Switch to Standby parameter in the R-net Power Module when using Single Switch
Scanner-Type SIDs.
8 SPEED ADJUST MODE
A Speed Adjust Mode screen as shown below will appear if the User Control parameter has been set to Sequence. Left and
Right SID commands will adjust the maximum speed setting.
The User Switch exits to the next available menu entry.
NOTE (HP, IN)
It is not advisable to program the menu option, ‘Speed Adjust’ if the Sequence method is being used with a Single Switch
Scanner-Type SID. Refer to the Programming chapter for further details.