Cuppone PZF/30, Руководство по эксплуатации и обслуживанию

Страница: 25 / 30

25
H
2
O
Fig. 24
Warnings
Before any cleaning, it is necessary to
switch off the
power
to the appliance (acting on the system switch),
wear suitable personal protection equipment (e.g.
gloves, etc.) and wait for all parts of the appliance to cool down.
The user must carry out only routine maintenance, for extraor-
dinary maintenance, contact a Service Centre requesting ser-
vice from an authorised technician. The Manufacturer warranty
does not cover damages due to negligent or incorrect mainte-
nance or cleaning (e.g. use of unsuitable detergents).
Any cleaning must be carried out with the product
completely cold and wearing adequate personal
protection devices (e.g. gloves, etc.).
When cleaning any part or accessory do NOT use:
• abrasive or powder detergents;
• aggressive or corrosive detergents (e.g. hydrochloric
or sulphuric acid, caustic soda, etc,). Caution! Never use these
substances also when cleaning the substructure/floor under
the appliance or its base;
• abrasive or sharp tools (e.g. abrasive sponges, scrapers, steel
brushes, etc.);
• steamed or pressurised water jets.
It is best to have an authorized service centre perform
maintenance and inspection on the appliance at least
once a year to ensure top working and safety conditions.
Cleaning the appliance
Cleaning the external steel parts
Fig. 24
Make sure that the power supply has been disconnected
and that the appliance temperature is not too high,
which could cause burns to the operator or damage the
cleaning tools.
Use a cloth soaked in hot soapy water and finish with a
thorough rinsing and drying, taking care to remove all traces
of detergent.
Degreasing and sanitizing of plates
Fig. 24
Make sure that the power supply has been disconnect-
ed and that the plates are at room temperature, so as
not to cause burns to the operator or damage the
cleaning tools.
If necessary, remove the coarser dough residues with a flat
scraper, being careful not to scratch the plates. Then, use a
cloth soaked in hot soapy water or, alternatively, use a neutral,
non-aggressive detergent suitable for cleaning components in
contact with food. Finish with a thorough rinsing and drying,
taking care to remove all traces of detergent.
Cleaning the display
Clean the display with a soft cloth and a little detergent for
delicate surfaces. Avoid using considerable quantities of
product since any infiltration may damage the display.
Avoid also using very aggressive detergents that may damage
the material the display is made of (polycarbonate).
Maintenance and cleaning
Ed. 0121 - 70702572 REV03 Pizzaform - Use and maintenance