www.cuesinc.com
,
18
CUES Inc.
,
Currahee Cutter User Manual | CK902
CUES Inc.
,
Currahee Cutter User Manual | CK902
19
4
SYSTEM SETUP & INSTALLATION
ELECTRICAL & PHYSICAL CONNECTIONS
Check to make sure that all equipment is OFF (0) before making any of the necessary connections
involving the Cutter system. Changing connections with power to the system can cause harm to the
operator and/or equipment failure.
Connect the system as follows:
1.
Attach the wheels as required for the size of pipe being reinstated as shown in Figure 1.
The suggested wheel sizes are shown on the Currahee Cutter Quick Card, P/N CK901.
Use anti-seize thread lubricant and torque screws to 7 ft-lbs.
2.
Attach the camera assembly as shown in Figure 2.
Position the bracket spacers on top of the screw head and between the bracket and cutter.
Install the bracket with the shoulder screw and spring washer. Secure using blue thread locker.
Connect the camera cable to the cutter connector, making sure to align orientation features.
The suggested orientations of the cutting camera for different pipe sizes are shown on the
Currahee Cutter Quick Card, P/N CK901.
3.
Attach the air motor housing as required for size of pipe being reinstated as shown in Figure 3.
Use anti-seize thread lubricant and torque screws to 7 ft-lbs.
Dual camera assembly can be rotated up for ease of access.
Attach the air hose from the cutter to the air motor housing.
NOTE: The air hose can be
detached from the air motor housing when rotating camera assembly up to prevent pinching.
The suggested housing sizes are as shown on the Currahee Cutter Quick Card, P/N CK901.
4.
Install the chosen air motor style into air motor housing.
Align the circular notch in the bottom of the air motor to face the air inlet of the air motor housing.
Prior to installation, apply a couple drops of air motor oil to upper bearing, lower bearing, and
on vanes through holes in air motor.
Use anti-seize thread lubricant on air motor retaining nut and snug down firmly.
Verify that air motor spins freely.
5.
Install the chosen cutting bit onto the air motor.
Threaded bits should be lightly snugged down onto the shaft.
Collet style bits should be tightened firmly.
6.
Attach the multi-conductor cable to the rear of the Cutter.
7.
Attach the strain relief cable located on the rear of the Cutter to the clam shell on the multi-
conductor cable.
NOTE: Adjust the clam shell on the multi-conductor cable until there is
slack in the cable.
8.
Attach the air and water hoses to the cutter.
