www.cuesinc.com
,
14
CUES Inc.
,
Currahee Cutter User Manual | CK902
CUES Inc.
,
Currahee Cutter User Manual | CK902
15
EQUIPMENT OVERVIEW, CONTROLS & SETTINGS
3
===== CUES CUSTOMIZABLE PARAMETERS =====
LONG PAUSE TIME(msec): 2000
SHORT PAUSE TIME(msec): 200
SKIP EQUIPMENT SCREEN: NO
VIDEO FORMAT: NTSC
CUTTING UP/DN:NML CCW/CW:NML FWD/REV:NML
DRIVING FWD/REV:NML
SPEED UP/DN: 60 CCW/CW: 60 FWD/REV: 60
VIDEO ON POWER SUPPLY: NO
DISTANCE UNITS: FT.
SAMPLING METHOD: AVERAGE QUANTITY: 1
DUC CRUISE: DUC ONLY
CRUISE SPEED PERCENT: 58
SWAP JOYSTICKS: NO
MPT/uPT/CAW RECONNECT (msec): 5000
INCLINE THRU PRESSURE: NO
UP/DOWN to set normal reverse polarity
C. DISPLAY
The K2 Run-Time Display Setup screen contains settings that control the information displayed onscreen
during operation (image below is for reference only). The following are the settings that pertain to the
CK600 Currahee Cutter.
========== CUES DISPLAY SET UP =========
FONTS: SMALL_OUT SCREEN TIMEOUT:None
MAIN DISTANCE: On RT FONT EBW 1, 1
LATERAL DISTANCE: ON HUMID:OFF 2, 1
TIME: On hh:mm AM 04:47 PM 3, 1
DATE: On MM/DD/YY 11/07/16 4, 1
PRESSURE:Off PSI ZERO? 5, 1
INCLINE:Off DEG. 5-DEGREE ZERO? 6, 1
TRANS SPEED:Off CUTTER SPD: ON 7, 1
TTL: Off 8, 1
MH-1: Off 9, 1
MH-2: 10, 1
DIR: Off 11, 1
LEN: Off 12, 1
CMT1: Off 13, 1
CMT2: 14, 1
ARROW UP/DOWN to view cutter speed list
ON
CUTTER SPEED
•
Select whether or not to display the three current cutter motor speeds on the K2 Run-Time
screen, titled over the video image.
•
The K2 also includes “hotkey” control over this setting, allowing it to be changed without having
to navigate to the Run-Time Display Setup menu screen. Press [F11] on the K2’s keyboard while
on the Run-Time screen to toggle the onscreen display of the cutter speeds back and forth
between ON and OFF.
D. MISCELLANEOUS
•
While in Driving Mode, the Currahee Cutter can be driven at a constant speed forward using the
K2 “DUC Cruise” function, if desired.
NOTE: Extra care must be taken to prevent damage to
pipes, liners, or other down-hole equipment when using cruise.
•
The K2 includes a Currahee-Cutter-specific ‘Help’ screen showing the primary controls, for
reference during operation. It can be accessed through the K2 menu system here:
MAIN MENU VIEW HELP TEXT CUTTER HELP SCREEN.
•
When using the Currahee Cutter, the rows of the table on the K2 Power Supply Status screen
are
renamed:
LIGHTS becomes FWD/REV, LT MOTOR becomes UP/DOWN, and RT MOTOR becomes CCW/CW
•
For additional information on these topics, please refer to the K2 User Manual on the CUES website.
