6
8. Software Upgrade
You may easily upgrade the
SDTU-01/ET10
embedded software
by obtaining the compressed upgrade kit from the service
provider then following the steps:
ü
Extract the ZIP file for updated firmware
ü
Connect
SDTU-01/ET10
via the local Ethernet port or remote
SDSL link, make sure the
SDTU-01/ET10
Ethernet IP address
and your terminal are properly configured so you can
successfully “
ping
”
SDTU-01/ET10
. The default local and remote
IP addresses are 192.168.2.1 and 192.168.1.1, respectively.
ü
Under DOS prompt, execute command
“xupgrade <
IP
address of SDTU-01/ET10>
”
, for instance “
xupgrade
192.168.1.1
”.
ü
This upgrading process might last as long as 60 seconds.
ü
Then reboot
SDTU-01/ET10
with new software.
NOTE: Strictly maintain stable power to SDTU-01/ET10 while
upgrading software, if power failed during the upgrading
process, contents in the memory could be destroyed
and the system will hang. In such case you must call the
dealer or system integrator to repair.