CSI Wireless Seres, Справочное руководство

Страница: 70 / 134

Seres Reference Manual
50
Figure 5-1 SLXMon Screen Capture
5.3 General Commands
This section presents various commands relating to the general operation
and configuration of the Seres.
The following table provides a brief description of the general commands
supported by the Seres smart antenna.
Table 5-1 General Commands
Message Description
$JASC,Dx Command to turn on diagnostic information.
$JAIR This is a command to place the receiver into ‘AIR’ mode where the receiver will
respond better to the high dynamics associated with airborne applications.
$JASC,VIRTUAL This command is used to output RTCM data fed into the other port, through
the current port
$JASC,RTCM This command is used to output RTCM data from the SBAS demodulator
$JALT This command is used to set the altitude aiding mode of the GPS inside the
Seres
$JAPP This command is used to query the current applications and also choose the
current application.
$JBAUD Baud rate change command for the Seres.
$JCONN Virtual circuit command used to interface to the internal beacon receiver or
communicate with the menu system microprocessor.
$JDIFF This command is used to set the differential mode.
$JK This command is used to subscribe certain features of use of the Seres.
$JPOS This command is used to provide the Seres with a seed position to acquire a
SBAS signal more quickly upon start-up. This is not normally needed.
$JQUERY,GUIDE This command is used to poll the Seres for its opinion on whether or not it is
providing suitable accuracy after the both SBAS and GPS have been acquired
(up to 5 min)
$JRESET This command is used to reset the configuration of the Seres.
$JSAVE This command is used to save the configuration of the Seres.
$JSHOW This command is used to query the Seres receiver for its configuration.
$JT This command is used to poll the Seres for its receiver type