Crow serenity, Руководство техника

Страница: 68 / 73

SERENITY – technician Guide
68
Address Description Default
keys will stay unlocked and free for use.
P327E
User code must be 4-8 digits long - If this option is turned on,
all user codes, installer code and remote access password must be
between 4-8 digits long. If it is turned off, the minimal length of
the code is one digit.
Disable
P328E
Enable Keypad Tamper - if this option is turned ON the keypad
tamper will be enabled and can cause to keypad tamper alarm if
keypad is removed from the wall. If this option is OFF, then the
keypad tamper will be disabled, opening or removing the keypad
from the wall will not cause to tamper alarm on panel.
Enable
P329E
Enable Outputs Tamper- Tamper alarm indication for any device
which is connected to Control Panel's output.
Enable
P330E
Maximum of report messages from a single source - The
maximum number of events recorded from any single source. The
value is limited from 3 to 10. The memory will show (recorded)
events from the blocked single source after a system session has
occurred (Arm-Disarm or Disarm-Arm
)
10
P376E
Control panel title - Enter identification title of control panel up
to 16 characters
Disable
P389E
Switch out 12V on - Switch on/off 12V on output connector
using for peripherals
Disable
11.2: Miscellaneous/User Options
Address Description Default
P331E
Code Required to View Memory and status - If this option is
turned on, access to view Memory Log, Status Window and Active
Time Zones while the Serenity is in disarm mode will only be
allowed by using an authorized code. If this option is turned off
anyone can access the modes at disarm. In any case, while
Serenity is in arm or stay arm mode an authorized code is
required to view memory.
Disable
P332E
Hide user codes from installer
-
This option is only accessible
from User Programming Mode. It is designed to allow the User
(owner) of the alarm to hide their User Codes from the Installer if
desired. If this option is turned On, codes can only be changed or
viewed in User programming mode. Users MUST have option at
location
[P22] assigned before they can hide the user codes.
Disable
P333E
Cancel Handover Zone Function in Stay Mode - If this option
is turned on, any zone programmed with the handover feature will
act as a normal delayed zone during Stay mode (i.e. the handover
feature will be ignored). The zone will still have the normal
handover feature during the full arm state.
Disable
P334E
Output Control from Keypad is Disabled when Armed- If this
option is turned on any User code programmed to operate an
output for access control will be disabled when the area(s)
assigned to the user is(are) armed (P14). If the user code is
assigned to area 1 but area 2 was armed the code can still operate
the output.
Disable
P335E
Keypad Codes are Disabled During Entry Delay - If this
option is turned on no codes will operate during the entry delay.
This forces the user to disarm before entering the premises.
Disable