19
OPTION DESCRIPTIONS
3 Pulse Start
- This mode allows the system to use the OEM Remote Control to Remote Start or Stop with 3
successive Lock pulses. There are 2 Modes of operation.
1.
Remote Start thru Data
(green wire not connected). This feature only works on newer CANBUS vehicle using a
Data Module that supports this feature. With this option you can use both the OEM and Crimestopper remote.
2. Connect the Green input wire to the Negative lock signal wire of the factory system. If your Factory OEM system
does not have this type of signal, then a relay is required.
18. MINIMUN STARTER CRANK TIME:
Default = 0.8 seconds
This option controls the Minimum Starter Cranking time. This does not affect maximum crank time. This can be adjusted
in 0.1 second increments Up or Down from 0.5 to 4 seconds. The starter can still crank up to 4 seconds with a 0.8 setting,
depending on Tach or Tachless setting.
TIMED START
, use Hybrid Mode (option 1-4) with this option to set a fixed crank time. Please Note: In Hybrid Mode
there is only 1 start attempt and the ignition is left on.
19. DIESEL GLOW PLUG DELAY:
This option controls the system’s Diesel vehicle interface. Using this option you can control whether the unit monitors the
vehicle’s glow plug circuit using the Pink input wire (Default), or you may select a specific delay time before cranking.
Selections: 10, 15 or 20 seconds.
Default = Monitor Pink Wire.
20. REMOTE START ENGINE RUN TIME:
Set engine run time for 10, 20, 30 or 5 minutes as desired.
21. Smart Tachless Voltage Adjustment:
This option controls the voltage reference point when using smart Tachless mode. Pressing the Lock or Trunk buttons on
the remote raises or lowers the reference level in 1% increments from 79%-100%. Button #2 (unlock) resets the unit to
the factory default reference point of 93%. The default 93% setting works for most vehicles.
22. TURBO TIMER: Using Remote Start Button
The optional Turbo Timer mode allows the CoolStart system to keep a Turbo or Turbo Diesel vehicle running for 1, 3
or 5 minutes [selectively] after you remove the key and exit the vehicle. This is handy for turbo cool-down without the
need for expensive turbo timers. The
Default = OFF.
23. UNLOCK ON START BUTTON:
While remote started, this option allows the remote start button to unlock the doors with a ½ second press.
24. ORANGE / WHITE WIRE SELECTION: Ignition / Accessory / AUX 2 Output -
Default = ACC
