6
WIRING Low Current 12 Pin Plug
GRAY: (-) NEGATIVE HOOD PIN SWITCH
Connect the Gray wire to a switch that is at ground when the hood is open. If an existing switch is not available, then we
recommend one to be installed. When this wire is grounded, the remote start is inhibited. The unit will not attempt to start
if hood is open.
ORANGE / WHITE (-) ACC, IGN or AUX 2 OUTPUT (Programmable option 24)
This output is selectable (-) Accessory, (-) Ignition or (-) AUX 2.
Default = (-) ACC
BLUE/ORANGE (-) STARTER OUTPUT:
Some vehicle require a (-) Start Activation for “Push to Start”.
ORANGE BLACK: (-) OEM DISARM OUTPUT
This wire provides a Ground pulse to disarm the vehicles' Factory anti-theft system prior to a Remote Start. Connect this
wire to the vehicles' anti-theft disarm wire. This wire is sometimes found coming off the Driver's door key switch or at the
Factory Anti-theft control module. This wire may not be needed if Factory Security only requires a door unlock pulse.
ORANGE: (-) OEM REARM OUTPUT or AUX 2 Output (programmable option 25)
This wire is programmable as OEM Rearm or 2
nd
Aux output. This wire provides a ground pulse to rearm the vehicles'
FACTORY anti-theft system after a timed-out or aborted remote start. Connect this wire to the vehicles' anti-theft rearm
wire or to the door pin circuit depending on your requirements. This wire may be needed to pulse the door pin circuit on
vehicles with retained accessory power.
YELLOW: (-) HORN CHIRP HONK OUTPUT (Programmable 15, 20 or 40 milliseconds, Option 16)
Connect to the LOW CURRENT Negative Horn Trigger wire usually located near the steering column. If the vehicle horn
circuit requires 12V, then a relay is required. RELAY WIRING: Connect the Yellow wire to terminal #85, connect relay
terminals #86 and #87 to 12V constant power. Connect terminal #30 to the 12V positive Horn activation wire.
PINK: NEGATIVE GLOW PLUG (Programmable for fixed time delay, Option 19)
Connect Pink wire to indicator circuit that shows a (-) Signal while the WAIT TO START LAMP is on. When this wire is
used, the system will wait until light turns off before attempting a remote start.
Note: Used for Manual Transmission Door Trigger Input, Option 11
