7
WIRING Low Current 12 Pin Plug
RED WHITE: TACHOMETER INPUT
When installing the system in Tach mode, this wire must be connected to a valid source of AC voltage. This wire allows
the unit to sense the engine running and control the starter motor.
PURPLE: (12V) BRAKE RESET
Connect the Purple wire to the side of brake pedal switch that shows 12 volts ONLY when pedal is depressed. This is the
wire that turns off the remote start once the driver’s key is in the Ignition and turned to the ON position.
GREEN (-) START ACTIVATION INPUT or OEM INTERFACE (3 Pulse Start)
Option 17-1
OEM Interface (3 Pulse Start):
This mode allows the system to Remote Start or Stop with 3 successive Lock pulses. There are 2 Modes of operation.
1. Remote Start thru data (green wire not connected). This feature only works on newer CANBUS vehicle using a
Data Module that supports this feature. With this option you can use both the OEM and Crimestopper remote.
2. Connect the Green input wire to the Negative lock signal wire of the factory system. If your Factory OEM system
does not have this type of signal, then a relay is required.
Option 17-2
Default (-) Neg. Start Activation:
This wire allows an alarm or keyless entry system with a remote Aux channel to activate the Remote Start by sending a
(-) momentary pulse to the Green input wire. This triggers a remote engine start or stop
WIRING LED and Valet Switch
PROGRAM OVERRIDE SWITCH: 2 PIN PLUG (REQUIRED FOR PROGRAMMING & LEARNING REMOTES)
This is a multi-function switch used for programming options, transmitters, valet mode.
LED: 2 PIN PLUG
The LED is used for Remote Start Diagnostics and a Valet indicator. It will also Flash for use as security deterrent.
VALET / PROGRAM SWITCH
STATUS LED
