22
MANUAL TRANSMISSION MODE
MANUAL TRANSMISSION INSTALLATION: OPTION 11
TACH WIRE = White/Red must be connected and programmed. (Default = Tachless Mode)
PINK WIRE = (-) Door Switch (default = Glow Plug)
GREEN WIRE = (-) Hand Brake (default = OEM Start)
After programming Option 11-1, 11-3 or 11-4 for manual transmission mode, the Door Trigger and Hand Brake wire must
be connected for the manual transmission remote start procedure. The Pink “Glow Plug” wire becomes a Door Pin input
and the Green “OEM Start” wire becomes a Hand Brake input that must be used for the manual transmission remote start
procedure. A Databus module can also supply the Door, Hand Brake status and Tach signal on most late model vehicles.
Please check Databus module features before connecting door and hand brake wires. A door opening will now cancel a
remote start that was previously “set-up” by the user. The Hand Brake and Door Trigger is a safety feature to cancel a
remote start.
Note: You can’t use the interior lights as a door trigger if the interior lights turn on with ignition off.
OPTION 11 - TRANSMISSION TYPE: Manual Transmission Requires Tach Wire Connected and programmed.
This option selects automatic or manual transmission mode - 3 Choices of operation.
1.
Manual Shift Transmission - Requires Remote Start Button pressed with (-) Hand Brake set.
2. Automatic Transmission – Default.
3.
Manual Shift Transmission – Starts Exit procedure with (-) Hand Brake Set and engine running.
4.
Manual Shift Transmission – Starts Exit procedure with (-) Hand Brake Set, engine running and auto shut down after
last door closed.
Manual Transmission Exit Procedure:
1.
Option 11-1:
With engine running and vehicle in neutral, set parking brake, then press “Start” button on transmitter. The remote
starter will turn on and take over operation of the vehicle.
2.
Option 11-3:
With engine running and vehicle in neutral, set parking brake. The remote starter will turn on and take over operation
of the vehicle.
3.
Remove key, exit vehicle (remote starter unit must “SEE” door opened, then closed with engine running).
4.
Press Lock button within 10 seconds of closing door for “Idle Down” (engine stays running). Press Lock a 2
nd
time to cancel “Idle
Down” (engine turns off) and set up Manual Transmission Mode.
5.
Press Lock button after 10 seconds to Lock the doors and shut down the engine. From this point, the system will remote start engine
unless a door is opened.
NOTE:
Pressing the Remote Start or Lock Button after closing door to set up Manual Transmission Mode
is not required with option 11-4
