3
INSTALLATION CAUTIONS & WARNINGS
DO NOT
extend the Remote start ignition harness length. Mount the module so that main harness reaches all ignition
switch wiring. Extending these wires could result in poor or improper performance.
DO NOT
route any wiring that may become entangled with brake, gas pedals, steering column or any other moving parts
in the vehicle.
DO NOT
exceed the rated output current of any circuit on the Remote start module. Failure to observe this warning will
result in damage to the unit not covered under warranty.
DO NOT
remote start the vehicle in a closed garage! Make sure that the garage door is open or there is adequate
ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide fumes.
WIRING 6 Pin Power Plug
RED: 12 Volt Power Source 10 Amp
Connect to a constant power source at battery or fuse box when powering the Pink and Pink/white wire. The ignition
switch on many new vehicles have only a 2 or 3 amp power wire so this can not be used. Not necessary to connect
when using a Data Module with a “T” harness plug. The data plug can supply 1 amp to operate the electronics.
BLACK: MAIN SYSTEM GROUND
Connect to chassis metal of the vehicle. An existing bolt or screw may provide an adequate ground, or drill a small hole,
scrape away paint and attach using a sheet metal screw & star washer. This wire must be connected to a proper ground
or undesirable and inconsistent operation will occur. Do not use Factory ground locations.
PINK/WHITE: Programmable Option #4
This is an optional multi-function output wire the can be configured as a Second IGN, ACC or STARTER output. Use
Option #4 to select ACC, IGN or STARTER. The DEFAULT setting is IGNITION.
PINK: Ignition Input/Output 10 Amp Max
This is the ignition source for programming system. This also supplies 12 volts out during Ignition and Start for remote
starting vehicle. Some data modules supply this function so may not be necessary to connect. Consult installation
guide of data module
