Crestron Isys TPS-5000, Руководство по эксплуатации

Страница: 24 / 56

12 Inch Tilt Touchpanel Crestron Isys™ TPS-5000
touchpanel and a PC to load files to a touchpanel without a network connection. In
the event that modular cables or an RJ-11 to DB9F adapter is not available, the
following table and diagram provide information so that the cable can be fabricated
on site. Refer to “RS-232 Menu” on page 13 for proper RS-232 port configuration
settings. Also refer to “Appendix A: RS-232 Protocol” on page 44 for protocol
details.
RS-232 Pinouts
PIN # DESCRIPTION
1 CTS
2
GND
3 RXD
4
TXD
5 RTS
6
N/C (Not connected)
1 6
1 6
Front
Top
PC to TPS-5000 Cable Specifications (Crestron Cable Number STCP-502PC)
RGB
This port is blank until the TPS-XVGA expansion card is purchased and installed.
Consult the latest revision of the TPS-XVGA Operations & Installation Guide (Doc.
5868) for details.
NOTE: RGB connector is only available after installing the expansion card into the
TPS-5000 touchpanel.
NET/VIDEO
This 10-pin RJ-45 connector mates with the TPS-IMPC or TPS-IMW interface
module using a supplied cable and has a dual purpose.
CAUTION: The 15-foot, 10-pin RJ-45 connector cable supplied by Crestron is a
custom cable and is the only one that should be used. The end of the cable has a
metal shield that is required to protect the equipment. Using non-Crestron cables will
result in damage to the product. Other cable lengths are available from Crestron.
NOTE: When connecting the touchpanel to the interface module, do not confuse the
8-pin audio cable with the 10-pin net/video cable.
20
•
12 Inch Tilt Touchpanel: Crestron Isys™ TPS-5000 Operations Guide - DOC. 5863A