Crestron Isys TPS-5000, Руководство по эксплуатации

Страница: 41 / 56

Crestron Isys™ TPS-5000 12 Inch Tilt Touchpanel
4. To verify communication, select Diagnostics | Establish Communications
(Find Rack) . This should display a window that gives the COM port and
baud rate. If communication cannot be established, refer to the
“Troubleshooting Communications” section in the respective Operations
Guide for the control system.
Uploading a SIMPL Windows Program
A control system source file has
the extension .smw. A compiled
SIMPL Windows file has the
extension .spz for a 2-Series
control system, .bin for CNX
generation, and .csz for CNX
generation with SIMPL+.
The SIMPL Windows file can be uploaded to the control using SIMPL Windows or
via the Crestron Viewport.
Upload via SIMPL Windows
1. Start SIMPL Windows.
2. Select File | Open to view the “Open” window, navigate to the SIMPL
Window file (.smw), and click Open .
3. Select Project | Transfer Program .
Upload via Crestron Viewport
1. Verify that the procedure for “Communication Settings” that begins on page
34 has been performed.
2. As shown after this step, select File Transfer | Send Program
(alternatively, press Alt+P ) from the Viewport menu.
File Transfer | Send Program Command
3. The “Send Program” window appears, as shown after this step. Click
Browse , locate the compiled file (.spz) and click Open . This will display
the program's header information and enable one or both of the What to
Send check boxes. If the program does not contain any SIMPL+ modules,
only the SIMPL Program check box will be enabled. If it does contain
SIMPL+ modules, then the SIMPL+Program(s) check box will also be
enabled. Select one or both check boxes and then click Send Program to
begin the transfer.
NOTE: Refer to the respective Operations Guide for the control system for details
about the other fields shown on the “Send Program” window.
Operations Guide - DOC. 5863A 12 Inch Tilt Touchpanel: Crestron Isys™ TPS-5000
•
37