80 • DM NVX® 4K60 4:2:0 Network AV Encoders and Decoders
Product Manual — Doc. 9219A
NOTES:
o
If CEC or RS-232 is selected, error messages may appear in the Power Off and
Power On sections indicating that one or more command strings are invalid. The
messages are displayed until valid command strings are entered in the Command
or Command String text boxes as applicable.
o
If Infrared is selected, an IR file (*.ir) must be loaded to the DM NVX device. For
information about loading an IR file, refer to
.
l
Output Timeout: (DM-NVX-D200 only) Specifies the number of seconds that must pass in
which no signal is detected at the HDMI output before the output becomes inactive and
the display device automatically turns off.
In the drop-down list, select one of the following: 5 seconds, 10 seconds, 15 seconds, 30
seconds, 60 seconds, 90 seconds, or Custom. The default setting is 5 seconds.
l
Custom Output Timeout: (DM-NVX-D200 only, applicable when Output Timeout is set to
Custom) In the scrollable text box, enter or select the desired number of seconds. Valid
values range from 1 to 600 seconds. The default setting is 5 seconds.
l
Turn Off Output: (DM-NVX-D200 only) By default, Turn Off Output is disabled (the toggle
switch is in the Off position). To enable Turn Off Output, set the toggle switch in the On
position.
When Turn Off Output is enabled, the output turns off based on the Output Timeout or
Custom Output Timeout setting. When Turn Off Output is disabled (default setting), the
output remains active regardless of the Output Timeout or Custom Output Timeout
setting.
l
Active Port: (Applicable when Infrared is selected as the command interface) Port 1 is the
only available selection for the active IR port.
For CEC, RS-232, and Infrared command interfaces, configure Power Off and Power On settings
as applicable. Refer to the
Power Off and Power On Using CEC
,
, and
Power Off and Power On Using Infrared
sections for information.
