11
Creotech Instruments S.A.
tel. +48 22 233 10 27
ul. Gen. L. Okulickiego 7/9
e-mail: [email protected]
05-500 Piaseczno, Polska www.creotech.pl
8.
Disconnect the patch cord and connect the IP Power Strip to the target network cable.
9.
Restore the TCP/IP protocol settings of the PC computer. Connect the PC to the target
network (wireless or wired connection).
10.
Verify the configuration by logging in through the new Ethernet network.
11.
Start regular operation of the IP Power Strip
2.6.1.1
Changing the network configuration of the PC for the first start-up
procedure
The factory settings of the IP Power strip network protocol are following:
IP address (static):
192.168.1.201
Login:
admin
Subnet mask:
255.255.255.0
Password:
123456
DHCP:
Disabled
Default outlet state:
all OFF
To communicate with IP Power Strip for the first time, it is required to change the network protocol
settings of the computer used for the first configuration of the IP Power Strip.
Before making any changes to the TCP/IP protocol settings of a PC please write down the current
configuration (especially: DHCP status, IP address, Subnet mask).
Access the local area network configuration panel.
For Windows 7:
Control Panel / Network and Internet / Network and Sharing Center / Change adapter settings
OR
Click Start button, type ncpa.cpl in the Search box and press Enter.
Open properties window of the active Local Area Connection (make sure it is wired not wireless) by
clicking right button on appropriate icon and selecting Properties.
Change the TCP/IPv4 protocol settings of the PC computer to the following:
IP address (static):
192.168.1.101
Default gateway:
None
Subnet mask:
255.255.255.0
DNS:
None
DHCP:
Disabled
