Creo Color Controller C-80, Техническое руководство

Страница: 85 / 150

69
4.4.2 Color Controller C-80 Turns On, No Operating System
In this situation it is not possible to run the JOIND diagnostics software.
4.4.3 Color Controller C-80 Does Not Execute Commands
In this situation it is possible to run the JOIND diagnostics software.
Symptom Recovery Action
The operating
system does
not initialize. Verify the following:
•
The SATA2 cables and the power cables are
properly connected.
•
The system disk is not damaged physically.
•
The boot order is correct.
To verify the boot order:
1. Restart the server.
2. Press
DELETE
to enter the computer BIOS.
3. Use the arrow keys to select the Boot menu.
4. Verify the boot order is the same as shown in step
16 on page 57.
5. Reload the operating system; see page 39.
6. Replace the system disk.
Symptom Recovery Action
The FusionRA board
does not appear when
running diagnostics. 1. Verify that the FusionRA board is correctly
seated.
2. Replace the input memory located on the
FusionRA board.
3. Replace the FusionRA board.
A disk is not
functioning properly. 1. Check that the disk is correctly installed.
2. Verify that each SATA2 cable is connected
to the correct disk and system board
connector.
3. Verify that the voltage cable to each disk is
securely connected.
Several tests fail as a
result of a particular
failure. When there is a memory failure replace the
Fusion RA board and run tests on the board
again.