Creo Color Controller C-80, Техническое руководство

Страница: 132 / 150

116 Chapter 5—Hardware and Maintenance Repairs
Figure 36: Securing the CPU fan and heat sink assembly
5. Connect the CPU fan cable to the CPU Fan 6 connector. See Figure 25 on
page 110.
6. If you have other options to install or remove, do so now.
7. Return the FusionRA board. See Installing the FusionRA Board on page 100.
8. Return the rear fan. See Installing the Rear Fan on page 124.
9. Return the side cover. See Placing the Side Cover on page 95.
10. Reconnect all external cables and power cords, and turn on the server.
5.6.6 Replacing the Battery
If you need to replace the battery, use a lithium battery, model number CR2032. To
avoid possible danger, read and comply with the following safety statement.
The battery is located on the system board below slot 5. See Figure 13 on page 99.
Removing the Battery
1. Follow any special handling and installation instructions supplied with the
replacement battery.
See System Reliability Considerations on page 93.
2. Turn off the Color Controller C-80 and all peripheral devices. Disconnect all
external cables and power cords.
3
1
2 4
WARNING: There is a danger of explosion if the battery is replaced incorrectly.
Replace the battery only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer’s
instructions.
Note: After you replace the battery, reconfigure the Color Controller C-80 and
reset the system date and time.