Assembly
© Copyright 2005, Creative Playthings
Williamsburg
19687-100 rev s (10-17)
Page 8
MAintenAnCe inStruCtionS
your CreAtiVe PlAytHingS PlAy Set iS StAined At our fACtory.
StAining iS not needed At tHe tiMe of initiAl ASSeMbly.
re-staining information:
• Pigmented, exterior, water repellent stains are recommended and will provide an excellent barrier against moisture
without hiding the natural wood grain or leaving a film that may later crack or peel.
• We recommend that you apply stain according to the instructions and precautions recommended by the stain manufac-
turer.
• it should take three or more quarts to cover your set.
• Contact your local dealer or call Creative Playthings for our staining products.
• all rungs are pre-finished at the factory and do not require any finishing at the time of initial assembly.
• do not paint, or varnish rungs or steps.
• avoid using finishes that create slippery surfaces.
Maintenance:
• Wooden playground equipment will last for years with proper maintenance. maintenance of the play set finish will
vary depending on weather climate.
• as a safety precaution, check all hardware for tightness twice a month during use and at the beginning of each play
season. Tighten as required and specified in these instructions. do not over tighten.
• Check structure twice monthly during usage for any evidence of deterioration. if upon inspection, hardware has sharp
edges, rusted or structural pieces have signs of premature failure; replace them through Creative Playthings Customer
service.
• oil all metallic moving parts monthly during the usage season.
• The swings, trapeze, tent, rope ladders, and any other removable plastic accessories should be removed and taken
indoors when outside temperatures drop below 32° F (0° C).
• Wood will expand and contract as it adjusts to temperature changes and varying moisture conditions. Checks or cracks
are a natural characteristic of all wood and will not affect the strength or durability of the wooden components.
• To maintain the finish of your set, a light sanding and an application of an exterior stain will repair scratches and pre-
vent wood from aging prematurely.
• Finishes applied to ladder rungs must not create a slippery surface. never varnish or paint! When refinishing rungs,
sand lightly and use an exterior stain or boiled linseed oil.
• The wood parts of your play set should never be disposed of by burning.
• dispose of all parts so as not to create a hazard.
tools & Materials Suggested for finishing & Assembly:
• Claw hammer
• Carpenter’s level
• box Wrench or sockets (7/16" & 1/2")
• electric drill
• 1/8", 5/16" and 3/8" drill bits (high speed)
• screwdriver (#2 Phillips) or drill with screw bit
• locking Pliers
• 10 ft. Tape measure
• Framing square
• 6 ft. step ladder
• beeswax or soap (used to lubricate screw threads)
