Assembly
Williamsburg
19687-100 rev s (10-17)
© Copyright 2005, Creative Playthings
Page 17
ASSeMbly inStruCtionS
SteP 22 - rear wall Slats:
Fasten six Wall slats (v) to the rear Platform end (W) and
the rear end Tent support (X), as shown. use four #8 x 1-5/8"
Flat head Wood screws in each Wall slat (v). There should
be approximately 2-1/2" between each Wall slat (v), except
in the center where there may be a conflict with the Tent Post
(Y). in the center the gap will be 3-1/4"
note: When placing Wall slats, leave no gap larger than
3-1/2" except at entrance or exit points. The right Wall sup-
port has been omitted from the illustration for clarity.
SteP 23 - left wall Slats:
Fasten six Wall slats (v) to the left Platform side (P) and the
rear left Wall support (r), as shown. use four #8 x 1-5/8"
Flat head Wood screws in each Wall slat (v). There should
be approximately 3-1/8" between each Wall slat (v).
note: When placing Wall slats, leave no gap larger than
3-1/2" except at entrance or exit points. The right Wall sup-
port has been omitted from the illustration for clarity.
SteP 24 - right/entrance wall Slats:
locate the two entrance Wall slats (u) and three Wall slats
(v). Place one entrance Wall slat (u) 2" from the front right
Corner Post. Fasten the entrance Wall slat to the inside of
the right Platform side (Q) and right Wall support (s) using
four #8 x 1-5/8" Flat head Wood screws. Fasten the other
entrance Wall slat (u) 17" from the first entrance Wall slat
using four #8 x 1-5/8" Flat head Wood screws.
evenly space the three Wall slats (v) between the entrance
Wall slat and the right rear Corner Post, as shown. The
spacing should be approximately 2". Fasten the Wall slats
using four #8 x 1-5/8" screws.
note: When placing Wall slats, leave no gap larger than
3-1/2" except at entrance or exit points.
v
P
r
u
v
Q
s
17"
iMPortAnt:
The gap between a Wall slat and an adjacent
element musT never be greater than 3-1/2" unless the
gap is greater than 9".
