Assembly
NORTHBRIDGE WOOD ROOF
19950-100 Rev C (05-18)
© Copyright 2016, Creative Playthings
Page 19
ASSEMBLY INSTRUCTIONS
STEP 29 – Swing Mount & Swing Beam:
Find the center of the Main Beam on the back of the tower. (The Bolts securing the Center Block are at the center of the Main
Beam). Mark the Main Beam 3" from the center of the Beam and 1-1/2" from the top edge of the Beam. Drill a 3/8" diameter
hole through the Main Beam at the mark.
Find the Swing Mount in the Classic Pine Swing Beam box.(See below right for an illustration of the part). Hold the Swing
Mount against the Back of the Main Beam and End Support/End Tent Support. Align the hole near the bottom with the newly
drilled hole in the Main Beam. Use a level to make sure the Swing Mount is plumb.
STEP 28 – Ceiling Joists:
Adjust the Roof Panels so the angled ends are even with
each other. Fasten a Ceiling Joist (AN) to the outside of
the Roof Rafters on each end. Use two 5/16 x 3" Hex Bolt
Assemblies.
Fasten the remaining Ceiling Joists to the other Roof Raf-
ters using two 5/16 x 3" Hex Bolt Assemblies.
STEP 27 – Roof Panels to Corner Posts:
Fasten one Roof Panel to the left front and left back Post As-
semblies with one 5/16" x 4-1/2" Hex Bolt Assembly in each
Post as shown. Do not completely tighten these bolts.
Repeat with the other Roof Panel on the right Uprights. Rest
the angled ends Roof Panels against each other.
AN
3"
1-1/2"
Center line of
Main Beam
Outline of
Swing Mount
Back of tented gym is
shown; wood roof gym
is similar.
End Support
Main Beam
Mark the position of the up-
per hole on the End Sup-
port. Drill a 3/8" diameter
hole through the board at
the mark.
Fasten the Swing Mount
to the Main Beam and End
Support using two 5/16 x
4-1/2" Hex Bolt Assemblies
as shown at right.
5/16 x 4-1/2" Hex Bolt
5/16 x 4-1/2" Hex Bolt
Install the Swing Beam as
instructed by the assembly
guide included with the Beam.
Swing Mount
