© Copyright 2016, Creative Playthings
NORTHBRIDGE WOOD ROOF
19950-100 Rev C (05-18)
Page 16
ASSEMBLY INSTRUCTIONS
STEP 20 – Rung Support:
Slide the holes in the Rung Support (P) over the ends of the
Rung Assemblies.
Fasten the top of the Rung Support to the Ladder Platform
End using one 5/16 x 3" Hex Bolt Assembly.
Fasten the bottom of the Rung Support to the Rock Base
Rail using one 5/16 x 5" Hex Bolt Assembly.
Important Note: Reverse the Hex Bolt As-
sembly so the Weld Nut is on the outside
of the gym.
STEP 21 – Secure Rungs:
Secure the Rungs using #10 x 2-1/2" Self-Drilling Screws
through the pre-drilled holes from below. Drill the Screws up
through the steel pipe until the head of the screw is flush with
the surface of the wood.
STEP 22 – Stringers:
Fasten the Stringer (AF) to each Platform End in the position
shown using one 5/16 x 4" Lag Screw and Flat Washer in
each end. The wide surface of the Stringer should be flush
with the top of the Platform Ends.
Fasten the Swivel Stringer (AG) to each Platform End in
the position shown using one 5/16 x 4" Lag Screw and Flat
Washer in each end. The wide surface of the Stringer should
be flush with the top of the Platform Ends.
P
AF
AG
Front of the Gym
Front of
the Gym
Parts omitted
for clarity.
5/16 x 3" Hex Bolt
#10 x 2-1/2" Self-
Drilling Screw
5/16 x 4" Lag Screw
5/16 x 4-1/2" Hex Bolt
