Assembly
NORTHBRIDGE WOOD ROOF
19950-100 Rev C (05-18)
© Copyright 2016, Creative Playthings
Page 21
ASSEMBLY INSTRUCTIONS
STEP 33 – Tire Swivel & Tire Swing:
The Tire Swivel can be found in the Tire Swing box. Fasten
the Tire Swivel to the Bottom of the Swivel Stringer using
four 5/16 x 2-1/2" Hex Bolt Assemblies through the Swivel
Stringer and Center Deck Board as shown. Be sure to use
Weld Nuts at the top, set into the Center Deck Board.
Locate the Tire Swing Assembly (AT) and place it be-
neath the Gym Platform. Make sure that the hard-
ware is fastened firmly to the Tire and that the
chains are not tangled.
Using the included quick-links, fasten each chain
to the Tire Swivel, as shown. The height of the
Tire Swing should be adjusted by putting the
quick-link through a lower link in the chain. The
standard installation is to loop the quick links to
the third link from the End of the Chain.
Tighten the quick-links using a C-wrench.
AH
STEP 34 – Cargo Net:
Fasten the Cargo Net (AH) to the Stair Platform End by pass-
ing the end of each rope through a hole and tying a figure
eight or overhand knot. Approximately 1" of rope should ex-
tend beyond the knot when fully tightened. Pull down on the
cargo net to tighten the knots.
Fasten the bottom of the Cargo Net to the Rope Base Rail by
passing the end of each rope through a hole and tying a knot.
At least 1" of rope should extend beyond the knot.
It is important that the Cargo Net is as taut as possible. Peri-
odically check the knots are secure.
Be sure there is a space of at least 9" between the top
horizontal rope and the bottom of the Stair Platform End.
Deck Boards shown cut-
away for clarity. Do not
cut Deck Boards when
assembling
Use the 3rd link
on each chain.
Overhand
Knot
Figure 8
Knot
≥ 9"
5/16 x 2-1/2"
Hex Bolt
STEP 35 – Wall Slats:
Evenly space six Wall Slats (B) between the back Post
Assemblies.
Hold the Wall Slats 1/2" above the Deck
Boards.
Fasten each Wall Slat to the back End Support and
the back Main Beam using four #8 x 1-5/8" Screws. The gap
will be approximately 2-3/8" between slats.
Secure one Wall Slat 24-3/8" from the right front Post
using four #8 x 1-5/8" Screws. Evenly space two Wall Slats
between the back front left Post and the Wall Slat.
Hold the
Wall Slats 1/2" above the Deck Boards.
Fasten each Wall
Slat to the front End Support and the front Main Beam using
four #8 x 1-5/8" Screws. The gap will be approximately 2-3/4"
between slats.
B
1/2" gap
below all
Slats
2-3/8" typical
2-3/4"
typical
Back of the
Gym
24-3/8"
#8 x 1-5/8"
Screw
