Crane ELRO IP 100, Инструкция по установке и эксплуатации

Страница: 9 / 44

9
Peristaltic Pumps Series IP 100-800
To avoid slippi ng of the loop, the
rope must be crossed over on the
hook.
If the pump is not installed immediately, it
should be packed up again and stored in a
suitable place. For this the following points must
be observed:
• All pump ports must be closed with
appropriate plugs.
• Pumps with corrosion protection must be
packed up again and stored in the original
packaging material.
• The pump is to be stored in a clean, dry and
vibration insulated place. The pump should
be covered with a material that provides
sufficient protection against dampness, dust,
dirt and other contaminants.
1.1 Warranty
The correct function of each ELRO peristaltic
pump is checked in the factory before
shipment. The manufacturer or authorized
dealer assumes warranty for the product as
specified in the effective terms of sales and
delivery. Faults resulting from the non-
compliance with the afore mentioned
regulations and notes can only be rectified at
the cost of the customer.
1.2 Transport, storage
In order to avoid any problems you should
• check the delivered goods against the
delivery note for completeness and
correctness,
• check pumps with drive units for availability of
the instructions manual for the drive upon arri-
val of the goods.
Be careful when unpacking the pump and
proceed as follows:
• Examine the packaging for transport damage.
• Take the pump carefully out of the packaging.
• Examine the pump for any visible damage.
• Remove all plugs from the pump ports.
Consider the indicated weight
before attempting to lift the pump.
Use only lifting gear of appropriate
capacity.
Do not step or stand under
suspended loads.
Pumps without drive: The hoisting rope must
be slung around pump body and drive shaft.
Pumps with drive: The hoisting rope must be
slung around pump body and motor.
In order to avoid slipping of the sling, the rope
must be crossed over at the hook.
Caution!
Caution!