Crane ELRO IP 100, Инструкция по установке и эксплуатации

Страница: 40 / 44

40
Peristaltic Pumps Series IP 100-800
1. Switch off the pump and secure it against
restarting.
2. Drain off the lubricating fluid (see chapter
5.11.1)
3. Remove pump cover with O-ring.
4. Turn the rotor by hand until one sliding shoe
is free.
Fig. 59
5. Then the shims (Fig. 59) must be removed to
reduce the pumping pressure or additional
shims must be added to increase the
pumping pressure.
If shims are changed, you must make sure that
both sliding shoes are changed to the same
dimension. The measurements must comply
exactly with the table (see below).
6. Fasten the pump cover again with O-ring
(see chapter 5.11.3).
7. Replace the oil drain plug.
8. Refill with lubricating fluid.
9. Replace the oil fill plug.
Version with rotor design (up to 2000)
Pressure Diameter - rotor
IP 600 IP 800
0 - 4 bar 543 mm 724 mm
4 - 6 bar 544 mm 726 mm
6 - 8 bar 547 mm 727 mm
8 - 10 bar 551 mm 728 mm
10 - 13 bar 552 mm 730 mm
Version with rotor design (from 2001)
Pressure Diameter - rotor
IP 600 IP 800
0 - 2 bar 543 mm 722 mm
2 - 4 bar 543 mm 724 mm
4 - 6 bar 544 mm 725 mm
6 - 8 bar 547 mm 727 mm
8 - 10 bar 551 mm 728 mm
10 - 13 bar 552 mm 730 mm
Version with rotor design (up to 2000)
Pressure Diameter - rotor
IP 600 IP 800
0-58 psi 21.38 inches 28.50 inches
58-87 psi 21.42 inches 28.58 inches
87-116 psi 21.53 inches 28.62 inches
116-145 psi 21.69 inches 28.66 inches
145-188,4 psi 21.73 inches 28.74 inches
Version with rotor design (from 2001)
Pressure Diameter - rotor
IP 600 IP 800
0-29 psi 21.38 inches 28,43 inches
29-58 psi 21.38 inches 28.50 inches
58-87 psi 21.42 inches 28.54 inches
87-116 psi 21.53 inches 28.62 inches
116-145 psi 21.69 inches 28.66 inches
145-188,4 psi 21.73 inches 28.74 inches