Craftsman CMXGLAM1143200, Инструкция по эксплуатации

Страница: 8 / 48

8
ASSEMBLY
WARNING
Take extra care when raising and lowering the beam as it is heavy. Having a
second person assist with raising or lowering the beam is recommended. Be
sure to keep hands away from any possible pinch points.
13. Disconnect the dislodger from the beam weld bracket by removing the six
hex screws. See Figure 5.
Hex Screws
Dislodger
Figure 5
14. Disconnect the log cradle from the beam on the side of the control valve
by removing the two hex washer screws that secure it to the beam and the
two hex washer screws in the beam flange. The cradle is off-set for shipping
purposes. See Figure 6.
Hex Washer Screws
Log Cradle
Figure 6
15. Lift and slide the cylinder up to the top of beam and place the cylinder
trunnions into the cylinder mount brackets as shown in Figure 7.
Cylinder
Mount
Bracket
Cylinder Trunnions
Figure 7
16. Attach the dislodger over the wedge assembly and secure it to the weld
brackets with the previously removed hex screws.
NOTE: Once the six hex screws are tightened, there may be a slight gap
between the dislodger and the weld brackets. This gap is normal.
17. Reattach the log cradle to the side of the beam with the control valve,
aligning the holes in the cradle with the holes in the beam. See Figure 8.
Hex Washer Screws
Figure 8
18. Check for and remove any staples on the bottom of the crate that may
puncture the tire.
19. Cut the metal strap securing the log splitter to the bottom of the crate and
remove the wood under the engine and/or any other wood, then roll the log
splitter off the bottom of the shipping crate.