Craftsman CMXGLAM1143200, Инструкция по эксплуатации

Страница: 7 / 48

7
ASSEMBLY
WARNING
Use extreme caution unpacking this machine. Some components are very
heavy and will require additional people or mechanical handling equipment.
NOTE: Your log splitter is shipped with motor oil in the engine. However, you MUST
check the oil level before operating. Be careful not to overfill. See Gas and Oil Fill-Up
in this section.
NOTE: All references in this manual to the left or right side of the log splitter are
from the operating position only. See Operator Zone in the Operation section of the
Safety Instructions.
NOTE: A minimum of two people are recommended to assemble this unit.
Unpacking & Assembling the Log Splitter
TOOLS NEEDED:
Safety glasses, leather gloves, wire cutters, pry bar and/or claw
hammer.
1.
Use a pry bar or claw hammer to loosen and remove the top of the crate.
2. Use a pry bar or claw hammer to remove the sides of the crate, beginning
with the short sides (or front and back side of the log splitter). Set the sides
of the crate aside to avoid injury.
3. On the front side of the crate the tongue assembly is attached on the inside of the
crate with straps. Cut the cable tie to remove tongue.
4. Remove the large plastic cover and discard.
WARNING
Do NOT remove any wood or cut any straps securing the log splitter or its
components to the log splitter or the crate at this time. Only remove straps
and/or wood when instructed to do so.
5. Inspect the bottom of the crate for any protruding staples or wood splinters
and remove.
6. Remove any loose parts included with the log splitter (i.e. operator’s manual,
etc.).
7. Remove the spring clip and clevis pin from the jack stand on the tongue then
pivot the jack stand towards the ground into the operating position. See
Figure 2.
Clevis Pin
Spring Clip
Jack Stand
Figure 2
8. Secure the jack stand in position with the clevis pin and spring clip. See
Figure 2.
9. With the log splitter still secured to the bottom of the crate, remove two
hex bolts and hex nuts from the tank bracket and remove the piece of wood
inside the tank brackets. See Figure 3.
Hex Nuts
Hex Bolts
Tongue
Tank Brackets
Figure 3
10. Align the holes in the tongue with the holes in the tank bracket and secure with
the hex bolts and nuts just removed. See Figure 3.
NOTE: The high pressure hose, which runs from the gear pump to the bottom
of the control valve, must be above the tongue assembly.
11. The log splitter is shipped with the beam in a vertical position. Remove any
bolts or straps securing the end plate to the bottom of the crate.
12. Pull out the vertical beam lock, rotate it back, and pivot the beam to the
horizontal position until it locks, being careful to avoid any possible pinch
points. See Figure 4.
B
2
A
1
Figure 4