page 9
9. Light Kit Assembly.
Remove 1 screw from motor plate (on underside
of motor) and partially loosen the other 2
screws. Align slotted holes in middle of fitter
plate with loosened screws in motor plate,
allowing molex connections from motor
housing to come through hole in middle of fitter
plate. Twist fitter plate to lock. Re-insert screw
that was just removed and tighten all 3 screws
securely.
Remove 1 screw from post, located in the center,
on underside of fitter plate and partially loosen
the other 2 screws.
Connect
WHITE
wire from motor housing to
WHITE
wire from LED light kit. Connect
BLACK
(or
BLUE
) wire from motor housing to
BLACK
wire from LED light kit. Be sure molex
connections snap together securely.
Arrange wires carefully within LED light kit. Align
slotted holes in LED light kit with loosened
screws from post located on fitter plate. Twist
the LED light kit to lock. Re-insert screw that was
previously removed and securely tighten all 3
screws. [
Refer to
diagram 2
.
]
Partially loosen 3 thumbscrews on outer edge of
LED light kit. Raise glass shade to LED light kit,
pushing up gently until lip on glass shade fits
securely inside LED light kit. Re-tighten
thumbscrews. [
Refer to
diagram 3
.
]
WARNING
: Do NOT overtighten thumbscrews as
glass may crack or break.
Make sure glass shade is secure by pulling down
GENTLY on glass shade.
Remove 4 screws from post located on
underside of fitter plate. Align holes in top of
glass shade support with holes on post. Secure
glass shade support with 4 screws that were just
removed. [
Refer to
diagram 3
.
]
LED light kit
LED light kit
glass shade
thumb
screw
shade support
motor housing
fitter plate
screw
molex connections
screw
screw
screw
screw
motor plate
motor
housing
fitter plate
diagram 1
diagram 2
diagram 3
molex
connections
