page 11
13. Testing Your Fan.
12. Remote Control Operation.
ON/OFF
slider switch - turns
wall control
ON or OFF
(switch not functional on handheld remote)
HIGH
button - turns
fan
to HIGH speed
MED
button - turns
fan
to MEDIUM speed
LOW
button - turns
fan
to LOW speed
OFF
button - turns
fan
OFF
L1
button -
turns
light kit
ON/OFF when pressed once;
dims
light kit
when pressed and held down
wall control
11. Automated Learning Process./Activating Code.
CAUTION
:
The wall and/or handheld remote control can be programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall control to the ON position. Within
60 seconds of turning on the wall control, press and hold the fan
OFF
button on the wall control for 5 seconds or
until light blinks twice.
Turn power off again for at least 5 seconds
and then turn power back on. Within 60 seconds of restoring the
power, press and hold the fan
OFF
button on the front of the handheld remote control for 5 seconds or until light
blinks twice.
Test the light and fan functions to confirm the learning process is complete--
see Section 13 below.
handheld
remote control
1
1
-
1
1
-
diagram 1
diagram 2
diagram 3
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable). Test wall
control (optional installation) by locating ON/OFF slider switch on wall
control, then set to the ON position. Test light and dimmer function
and then test fan speeds. Next, locate handheld remote control. Test
the light ON/OFF function by pressing the L1 button; test the dimmer
function by pressing the L1 button and holding it down for up to 5
seconds. Test fan speeds with the different fan speed buttons. If the
wall and/or handheld remote control operates all of the functions of
the fan, battery (batteries) has (have) been installed correctly. If the wall
and/or handheld remote control do (does) not operate all of the
fan/light functions, refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off
before
moving the reverse switch (located on
top of motor housing). Set reverse switch to recirculate air depending
on the season:
- LEFT position in summer (
diagram 1
)
- RIGHT position in winter (
diagram 2
)
A ceiling fan will allow you to raise your thermostat setting in summer
and lower your thermostat setting in winter without feeling a
difference in your comfort.
Important
: Reverse switch must be set either
completely LEFT
or
completely RIGHT
for fan to function. If the reverse switch is set in the
middle
position (
diagram 3
), fan will not operate.
NOTE
: If the wall control/handheld remote control interferes with other
appliances,
turn power off first
and then go back to the instructions in
Section 11.
reverse
switch
