page 7
8. Blade Assembly.
Time Saver:
Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in one of the hardware packs. Hold
blade arm up to blade and align holes. Insert
3 blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for the remaining blades.
Remove blade arm screws/lock washers from
underside of motor and if needed, locate the
others in one of the hardware packs. If plastic
motor locks are installed with blade arm
screws, discard plastic motor locks (
save blade
arm screws/lock washers to secure blade arms
).
Align blade arm holes with motor screw holes
and attach blade arm with blade arm
screws/lock washers. Before securing screws
permanently, repeat procedure with
remaining blade arms. Secure all screws.
Note
: Tighten blade arm screws twice a year.
blade arm
blade
blade attachment
screws and washers
motor housing
motor housing
plastic
motor
lock
lock washers
blade arm screws/
9. Light Kit Assembly (Optional).
If you wish to use your fan WITH the light kit
,
remove 1 screw from motor plate on underside
of motor housing and partially loosen the other
2 screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing
female plug from motor housing to come
through hole in middle of fitter plate. Twist
fitter plate to lock. Re-insert screw that was just
removed and securely tighten all
3 screws with a Phillips screwdriver.
["Light Kit Assembly" continued on next
page.]
fitter
plate
motor plate
female plug
