page 9
10. Handheld Remote Control Assembly (con’t).
In order to use wall control as a handheld remote
control, cut each wire on wall control (that was not
previously used)--use wire cutters to cut off each
wire as close to the wall control as possible.
[
Refer
to
diagram 2
.
]
Install one 12-volt battery (included) in wall
control.
[
Refer to
diagram 2
.
]
Since this fan comes with LED bulbs, the dimmer
switch (labeled
DIM
and
ON
) has been pre-set to
the "ON" position (
DIM
). If you do not wish to have
dimming capability, please move the switch to the
"OFF" position (
ON
).
[
Refer to
diagram 2
.
]
Attach
black faceplate
to front of wall control;
press down firmly.
[
Refer to
diagram 3
.
]
Align holes in wall control with posts located on
inside
of TOP part of remote control cover and
press together firmly. Place wall control into
BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post
holes in the bottom.
[
Refer to
diagram 3
.
]
(
NOTE
: Make sure to align narrower ends of
remote control cover before closing.) Squeeze top
and bottom of remote control cover together until
you hear a click at each end, indicating that the
remote control cover has closed completely.
IMPORTANT
: Store the remote control away from
excess heat or humidity. To prevent damage to
remote control, remove the battery if remote
control will not be used for long periods.
1
1
-
ON/ DIM
OFF
wall
control
face-
plate
remote control
cover,
BOTTOM
post
hole
diagram 3
post
hole
remote control
cover,
TOP
2
2
-
11. Automated Learning Process./Activating Code.
CAUTION
:
The wall and/or handheld remote control can be programmed to multiple receivers or fans. If
this is not desired, turn wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall control to the ON
position. Within 60 seconds of turning on the wall control, press and hold the
OFF
button on the wall
control for 5 seconds or until light blinks twice.
Turn power off again for at least 5 seconds
and then turn power back on. Within 60 seconds of
restoring the power, press and hold the
OFF
button on the front of the handheld remote control for 5
seconds or until light blinks twice.
Test the fan functions to confirm learning process is complete --
See Section 13 on next page.
dimmer
switch
wall control
wire
wire
wire
1
1
-
ON/ DIM
OFF
12V battery
diagram 2
2
2
-
