Craftex CX102, Руководство пользователя

Страница: 22 / 36

22
RE-SAWING
Cutting a work-piece into two or more
thinner pieces is called re-sawing. Wider
blades give better result, when re-sawing.
To re-saw a work-piece make sure that the
table is at a 90° with the blade and using a
wider blade will give better results.
Adjust the fence according to the width of
the cut you want, and lock it in position.
Turn the band saw ON and feed the work-
piece into the blade using feed paddles until
the blade is completely through the work-
piece.
Figure-36 Re-sawing on CX102
CUTTING CURVES
For cutting curves always try to use
narrower blades. When cutting curves feed
the stock into the blade and turn it very
carefully so that the blade follows the line of
cut and make sure the blade does not twist.
Make relief cuts through the waste part of
the work-piece which makes the job easier
and prevents the blade from twisting.
TABLE TILT
The CX102 is equipped with a 23” x 30”
table that can be tilted 10° right and 45° left
providing the user a wide range of cutting
options.
To tilt the table:
Turn the switch OFF and disconnect the
cord from the power source.
Loosen the table lock lever and the table
lock knob.
Tilt the table to the desired angle according
to the table tilt scale located under the
table.
Adjust the table stop adjustment so the
table rests on it.
Tighten the table lock lever and the lock
knob to secure the table in position.
Figure-37 Table tilt controls
WANRING
Make sure the power switch is in the
OFF position and cord is disconnected
from the power source, when making any
adjustments. Failure to do so may result
in serious personal injury or death.