Craftex CX102, Руководство пользователя

Страница: 24 / 36

24
MAINTENANCE
During the life of your machine, you will
need to practice some regular maintenance
to keep your saw in peak performance
condition.
The saw should be daily checked, for
damaged blade, loose mounting bolts,
damaged wires or any other unsafe
conditions and should be monthly checked
for loosen or damaged V-belts and dust
build ups inside the cabinet or on the motor.
V-BELT
The V-belt stretches with use, and should
be re-tensioned periodically. To ensure
optimum power transfer from the motor to
the blade, the belt must be in good
condition and under proper tension.
Check the V-belt at least after every month
and more often if the band saw is used
daily.
TO INSPECT THE V-BELT
1. Turn the power switch off and
disconnect the cord from the power
source.
2. Turn the hand wheel and release the
blade tension.
3. Remove the blade (See page-23
Removing the Blade).
4. Loosen the nut securing the wheel to
the saw body and remove the wheel.
5. Once the wheel is removed, you will
have access to the V-belts. Check if the
V-belts are in good condition and
tensioned properly.
TO REPLACE THE V-BELT
Follow the instructions 1-5 to access the V-
belt.
Loosen the nut securing the motor bracket
to the saw body and loosen the two hex
nuts holding the motor bracket up. See
figure-39
Once the nuts are loose, slide the motor up
to loosen the belt.
Figure-39 Hex nuts to be loosen to slide the
motor
Remove the old belt and install the new
one.
WANRING
When installing / removing and servicing
any part of the machine, make sure the
switch is in the OFF position and the
cord is disconnected from the power
source. Failure to do so may result in
serious personal injury or death.