Craftex CX102, Руководство пользователя

Страница: 13 / 36

13
TEST RUN
Once you have assembled your machine
completely, it is then time for a test run to
make sure that the machine works properly
and is ready for operation.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates strangely, stop the
machine immediately and disconnect from
the power source and investigate to find out
the problem with your machine.
CONTROL PANEL
The CX102 is equipped with a switch
featuring ON & OFF button and a key
feature which enables/disables the ON &
OFF controls.
To enable the ON & OFF controls, turn the
key to “1”.
To disable the ON and OFF controls, turn
the key to “0” and you can remove the key if
you want.
Figure-17 CX102 control panel
To make sure the control panel on your
CX102 is working properly, do the following:
Turn the key to “0” and push the ON button.
The key feature is not working properly, if
the band saw turns on.
Turn the key to “1” and push the ON button.
When the band saw starts, press the OFF
button to stop the wheels.
Every time when the band saw is turned
OFF, and you want to turn it back on, the
stop button will need to be pushed in and
turned clock-wise to reset. When the OFF
button pops out, the switch is reset and the
band saw is ready to be turned on.
Before starting the band saw, make sure
that you have read and understood the
manual and you are familiar with the
functions and safety features on this
machine. Failure to do so may cause
serious personal injury.
READ THE
MANUAL
IMPORTANT
When the work is done, turn the band
saw OFF, turn the key to “0” to disable
the ON & OFF controls and remove the
key to prevent any unauthorized
operation.