Craftex CX102, Руководство пользователя

Страница: 20 / 36

20
CONNECTING TO A DUST
COLLECTOR
CX102 features two 4” diameter dust ports
to connect to a dust collector.
When connecting to a dust collector, use a
proper sized hose and make sure all the
connections are sealed tightly.
Figure-33 Two 4” dust ports
WORK-PIECE INSPECTION
Before cutting the work-piece, make sure to
inspect it for nails, staples, small pieces of
stone or metal and any other foreign
objects which could come in contact with
the blade.
If the wood contains any of these objects
and it comes in contact with the blade, the
object might fly and hit the operator or
damage the blade. For safe cutting method
always inspect your work-piece carefully
before you cut and wear eye protection.
Some woods with excessive twisting or
wrapping are un-stable while cutting and
are dangerous to cut because during
operation the work-piece can move un-
expectedly which either damage the blade
or hurt the operator.
If the wood is slightly cupped, make sure
the cupped face of the wood is held against
the fence. If the bowed side of the work-
piece is held against the fence, the work-
piece will move while cutting.
Some stock with large knots can damage
the blade and wet stock will give a poor
result.
WARNING
The fine dust particles produced by the
band saw can go into your lungs and
cause serious health problems. Make
sure to wear a dust mask and connect
the band saw to a proper dust collection
system while operating it.
WARNING
The information above is just a guideline
for you to understand how to cut a work-
piece with slight cupping. If you are not
sure and do not have any experience in
cutting cupped stock, do not cut it.
Failure to follow these instructions might
bring personal injuries to the operator or
serious damage to the blade.