Craftex CX102, Руководство пользователя

Страница: 12 / 36

12
Figure-14 Blade tracking adjustment
Turn the knob clockwise:
If the blade moves towards the front edge
of the wheel. It makes the top of the wheel
to tilt back and moves the blade towards
the center.
Turn the knob counter-clockwise:
If the blade moves towards the back edge
of the wheel. It makes the top of the wheel
to tilt to the front and moves the blade
towards the center.
Figure-15 Blade centered on the upper
wheel
Once the blade is centered on the wheel,
tighten the lock nut.
Figure-16 Lower wheel tilting controls
Turning all four hex bolts shown in figure-
16, clockwise
in equal amount pushes the
lower wheel forward while turning them
counter-clockwise will bring the wheel
backward.
IMPORTANT
In very rare cases if the blade tracking is
not adjusted by tilting the upper wheel,
then you will have to make minor
adjustments to the angle of tilt of the
lower wheel to get the blade centered on
both wheels.
Loosen the four lock nuts shown in
figure-16 and turn the hex screws to tilt
the lower wheel to the desired direction
to get the proper angle of tilt and tighten
back the nuts.
Remember, this adjustment is done only
if the blade tracking is not adjusted by
tilting the upper wheel.