Craftex CX102, Руководство пользователя

Страница: 18 / 36

18
TABLE TILT SCALE
CALIBRATION
To calibrate the table tilt scale:
Make sure the table is at 90° to the blade
and the blade tensioning and tracking is
properly set. (See Page 11 & 15 for details)
Disconnect the machine from the power
source and loosen the pointer screw shown
in figure-28. Align the tip of the pointer with
the 0” mark on the table tilt scale and
tighten the pointer screw.
Figure-28 Table tilt scale and pointer screw
TABLE ALIGNMENT
To make accurate cuts with your band saw,
the table should be aligned properly with
the blade.
To align the table:
Make sure the blade tension and tracking is
adjusted correctly. Disconnect the machine
from the power source and loosen table tilt
bracket lock knob and screws securing the
table to the trunnion as shown in figure-29.
Figure-29 Loosening the screws
Place a straight-edge on the table so that
the straightedge touches the blade and is
parallel to it as shown in figure-30. Make
sure the straight-edge touches only the flat
part of the blade, not the teeth.
Now, use a ruler to measure the distance
between the miter slot and the straight edge
on both sides on the table R & L. See
figure-30.
Figure-30 Aligning the table
Adjust the table until the distance on both
sides of the table is equal and tighten table
tilt bracket lock knob and the screws
holding the table.