31
To Open the Door Manually
DISCONNECT THE TROLLEY:
The door should be fully closed if
possible. Pull down on the
emergency release handle (so that
the trolley release arm snaps into a
vertical position) and lift the door
manually. The
lockout feature
prevents the trolley from
reconnecting automatically, and the
door can be raised and lowered
manually as often as necessary.
TO RE-CONNECT THE TROLLEY:
Pull the emergency release handle
toward the opener at an angle so
that the trolley release arm is
horizontal. The trolley will reconnect
on the next UP or DOWN operation,
either manually or by using the door
control or remote.
To prevent possible SERIOUS INJURY or DEATH from a falling
garage door:
If possible, use emergency release handle to disengage
•
trolley ONLY when garage door is CLOSED. Weak or broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly.
NEVER use emergency release handle unless garage
•
doorway is clear of persons and obstructions.
NEVER use handle to pull door open or closed. If rope knot
•
becomes untied, you could fall.
Lockout position
(Manual disconnect)
NOTICE
Trolley
Release Arm
(In Manual
Disconnect
Position)
Trolley
To reconnect
NOTICE
Emergency
Release Handle
(Down and Back)
Trolley
Release
Arm
Trolley
Using the Wall-Mounted Door Control
THE PREMIUM CONTROL CONSOLE
Press the lighted push button to open or close the door. Press
again to reverse the door during the closing cycle or to stop the
door while it's opening.
Light feature
Press the Light button to turn the opener
light on or off. It will not control the opener
lights when the door is in motion. If you turn
it on and then activate the opener, the light
will remain on for 4-1/2 minutes. Press again
to turn it off sooner. The 4-1/2 minute
interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes as
follows: Press and hold the Lock button until the light blinks
(about 10 seconds). A single blink indicates that the timer is reset
to 1-1/2 minutes. Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes. Repeat again for a
3-1/2 minute interval, etc., up to a maximum of four blinks and
4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from hand-held remote
controls. However, the door will open and close from the door
control and the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2 seconds. The
push button light will flash as long as the Lock feature is on.
To turn off, press and hold the Lock button again for 2 seconds.
The push button light will stop flashing. The Lock feature will also
turn off whenever the “learn” button on the motor unit panel is
activated.
Additional feature when used with the 3-Function hand-held
remote
To control the opener lights:
In addition to operating the door, you may program the remote to
operate the lights.
With the door closed, press and hold a small remote button
1.
that you want to control the light.
Press and hold the Light button on the
2.
door control.
While holding the Light button, press and
3.
hold the Lock button on the door control.
After the opener lights flash, release all buttons.
4.
LOCK
LIGHT
Lighted
Push Button
Light
Button
Lock
Button
