Coyote CC2LP, Инструкция по использованию и уходу

Страница: 26 / 39

24
8) No stainless steel polish was ever used after one of the above mentioned acts took place.
Ways to Avoid Rust on your Grill:
1) Always purchase a Coyote Grill cover for your unit. This will ensure that your cover is correct fit and
breathable, while providing the protection needed to keep all other contaminants off of the surface.
2) When installing the unit, make sure to keep the unit covered when any masonry work is being
performed. If any mortar or dust does come into contact with the stainless, make sure to wipe it off
as soon as possible and use a stainless steel polish immediately afterwards.
3) Position your grill away from areas that can receive water splash from a pool or hot tub.
4) Do not store pool chemicals in your island or island cabinets.
How to Remove Scratches from your Stainless Steel:
If your situation is a little more serious and you have obtained scratches in your equipment, then you will
need to purchase a “stainless steel scratch kit.” These kits are popular in retail stores but can be easier
to obtain online. A very popular one is called “Scratch-B-Gone.” With these kits, you will not polish the
unit until you are done re-scratching the entire product you are working on. With a scratch kit, the goal is
to literally re-scratch the entire surface, so that the original grains are replaced by your new scratched-in
grains. With this practice, you must be willing to do the entire surface as you will notice a start and stop
point. Also, be careful to pay attention to your rolled or finished edges as these scratch kits will ruin this
finish. After you have used the kit, you will want to follow it up with a good stainless polish (as mentioned
prior) and then a dry towel for a final wipe down.
HOW TO CHANGE THE LIGHT BULBS
- (CC3 and CS Models only)
1. Remove the screw holding the bulb lens.
2. Reach in using your fingers only, grip the two outside edges of the light bulb, do not grip the top
or bottom of the bulb, as it might break. Pull the bulb straight out, so that the two electrode wires
are completely removed with bulb. Place bulb in trash.
3. When installing the new halogen bulb be sure to use a clean cloth or paper towel to ensure the
longevity of the bulb.
4. Insert the new bulb using your clean cloth and gently snap it into position. Wipe off any
fingerprints and/or grease that may have transferred to the bulb.
5. Re-install the bulb lens and cover
6. Flip the switch on to check lights.
ANNUAL CLEANING OF GRILL HOUSING
Burn-off the barbecue after every cookout will keep it ready for instant use, however, once a year you
should give the entire grill a thorough cleaning to keep it in top operating condition.
1. Shut off gas supply at source and disconnects fuel line. Protect fuel line fitting.
2. Remove and clean the cooking grids, flavorizers and burners.
3. Remove warming rack and wash with mild detergent and warm water.
4. Cover the gas valve orifices with a piece of aluminum foil.
5. Brush the inside and bottom of the grill with a stiff wire brush, and wash down with a mild soap and
warm water solution. Wash thoroughly and let dry.
6. Remove aluminum foil from orifices and check orifices for obstruction.