Coyote CC2LP, Инструкция по использованию и уходу

Страница: 15 / 39

13
Coyote’s Customer Service Department. Any other kit or orifices used that are not of Coyote brand, will
automatically void any warranty on the unit. Furthermore, it is important to understand that where ever there
is a burner, there is an orifice that will need to be changed (do not forget the rotisserie or sear burner).
The steps for converting your Coyote grills main and sear burners are:
1. Pull grill out of island or cart.
2. Remove Drip Pan and Cooking Grates
3. Unscrew bolt connecting the manifold pipe to the grill body, located at the back side of the grill.
4. Unscrew the 4 bolts holding the faceplate to the body (on the front edge where your cooking grate
sits)
5. Unscrew the 2 bolts (on each side) of the manifold and faceplate assembly, that holds this entire
assembly to the body of the grill.
6. Disconnect all wires and flex lines, from the valves and igniter assembly while paying close
attention to their original location.
7. Slide entire control panel and valve assembly out from the grill body.
8. Flip control panel over on its side, so you have easy access to the valves.
9. Sear Burner Grills Only – Remove center knob, unscrew top and bottom screws only.
a. The safety valve that controls the thermocouple on your sear burner must be completely
changed. You cannot change only the orifice.
10. Sear Burner Grills Only – Unscrew base bracket, hold center valve to gas manifold pipe and
remove valve
11. Sear Burner Grills Only – Install new Safety Valve in the correct gas type and follow the removal
instructions in reverse.
12. Once the panel is flipped over, you will see the orifice at the end of the valve. With a wrench remove
the orifice from the valve and install the new gas orifice,
13. Re-assemble in reverse and test all connections again with a soapy water solution to ensure no
leaks.
To convert your rear burner orifice:
1. Remove your entire rotisserie assembly
2. Remove the back panel that covers your rear rotisserie burner
a. With the hood open, remove the 4 screws on top of this panel
b. With the hood closed, remove the 4 screws on the back of this panel
c. With the hood closed, look underneath this same back panel and you will see 4-5 bolts
(depending on your grill), these only need to be loosened
3. Next, pull the entire panel (starting from the back) out from the grill
a. It is designed to fit tight, so you may need a flat head screwdriver to pop the stainless away
from the body
4. Next, you will see the gas line, brass elbow and orifice
5. Use a wrench to remove the orifice and install the new one
6. Re-assemble in reverse and check your back burner to ensure proper ignition and burning
Your grill is designed to reach a temperature that you set by adjusting a valve that in turns adjusts the
amount of gas that goes through each burner. This Valve is located behind your knob and is the key to your
Using Your Burners and Grilling Safely