Description:
Manual L4 ES HP; L4 ES HP W
Document Number:
1004289
Created By:
MSHN
Revision Approval Date:
2019-06-28
Revision:
A
© Corroventa Avfuktning AB
38 (42)
5.
Note!
Always use a suitable protective
mask when cleaning the rotor and
perform the work in a suitable location
outdoors.
Carefully blow clean the inside of the
rotor using compressed air. Hold the
nozzle about 15 cm from the rotor and
start blowing from the heat shield side
of the rotor. In this way, the air will
flow through the rotor in the opposite
direction to normal. This prevents more
dirt from getting stuck inside.
When you later clean from the other
direction, do not blow air into the heat
shield, otherwise dirt will accumulate
inside. Only blow on the rotor where
the opposite side is free and
unobstructed.
6.
Assemble the dehumidifier in reverse
order when the rotor has been cleaned:
•
Install the belt.
•
Install the AMP connector
•
Carefully lower the rotor unit into
the machine.
•
Reinstall the wet air hose.
•
Reinstall the four connectors.
•
When the cover is in place and its
four screws installed, ensure that
the tag washers, one at each end,
are also re-installed.
