Corghi HD 900, Руководство оператора

Страница: 48 / 182

48 - E
nglIsh
- Operator's manual HD 900
WHEEL CLAMPING
INSTRUCTIONS
WARNING
During the clamping phase, make sure that
the clamps are positioned correctly on the
rim to prevent the wheel from falling.
1) Move the mobile control unit to work-
ing position B.
2) Tilt the tool holder arm to the non-working
position.
3) Use the control lever to move the mobile
platform away from the turntable and raise the
wheel, keeping it in a vertical position.
WARNING
This operation can be extremely danger-
ous!
Perform it manually if you are absolutely
certain you can maintain the wheel equi-
librium only.
For heavy, large sized wheels you MUST
use a suitable lifting device.
4) Always using the control level, raise or lower
the turntable holder arm until centring the turn-
table as much as possible with the rim.
5) With the clamps closed, move the wheel
towards the turntable, translating the mobile
platform, then use the switch to open the turn-
table and clamp the rim internally in the most
appropriate position for the rim type, as shown
in figures
13A -13B - 13C - 13D 13E - 13F.
Please remember that clamping on the
central flange is always considered the
safest approach.
N.B. : for wheels with a rim well, clamp the wheel
so that the well is located on the outer side ( see
fig. 13A ).
CLAMPING EXTENSIONS
With wheels above 46”
in diameter and with-
out a flange with cen-
tral hole, the wheel
may be clamped using
the set of 4
PA exten-
sions (optional).
Bayonet-fit the exten-
sion onto the turn-
table clamp mount
and tighten with the
relative wing nut (
see
fig. 13G ).
13C 13D
13A
13B
13F
13E
13G