Corghi HD 900, Руководство оператора

Страница: 54 / 182

54 - E
nglIsh
- Operator's manual HD 900
first bead (see point 5), attach both of them.
- Lift the rim with the tyre hooked to it and turn it
15-20 cm anticlockwise (gripper at 10 o'clock).
- Follow the steps described in points 12-18 in
this paragraph.
MOUNTING WITH THE HOOK TOOL
1) Follow the steps described in points 1-6 for
mounting with the bead breaker disc.
2) Move the tool holder arm to the non-working
position; move it to the inner side of the tyre
and rehook it in this position.
3) Make sure that the hook tool is positioned
to the side of the wheel. Otherwise, press the
tool rotation lever and turn it 180°.
4) Move the mobile control unit to work-
ing position D.
5) Move the tool forward so that its red refer-
ence dot is aligned with the external edge of the
rim, 5 mm. away from it (
see Fig. 26 ).
6) Move the mobile control unit to work-
ing position C.
7) Move to the outside of the wheel and visually
check the exact position of the tool and adjust
it as needed. Then turn the turntable clockwise
until the gripper is at the lower point (6 o'clock).
The first bead is now in the rim.
8) Remove the gripper.
9) Move the mobile control unit to work-
ing position D.
10) Remove the tool from the tyre.
11) Move the tool holder arm to the non-working
position; move it to the outer side of the tyre
and rehook it in this position.
12) Turn the tool 180° using the tool rotation
lever.
13) Attach the gripper at the lowest point (6
o'clock) outside of the second bead.
14) Move the mobile control unit to work-
ing position C.
15) Turn the turntable clockwise approx. 90°
(until the gripper is in the 9 o'clock position).
16) Move the tool forward until its red reference
dot is aligned with the external edge of the rim,
5 mm away from it.
Start the clockwise rotation making sure that
after a 90° turn, the second bead has started to
slip into the rim well.
Turn it until the gripper is at the lower point
(6 o'clock).
The second bead is now also in the rim.
17) Proceed as described in points 13-18 for
mounting with the disc to correctly remove
the wheel.
26