TigoStarter K6
User Manual
Copyright © 2020 CoreTigo Ltd.
Page
24
of
32
3.5.
Show Revisions
This option will display the SW and HW revision info.
The W-Master revisions are displayed first and following it the connected W-Device revisions.
The date in the parenthesis indicates the compilation time of the revision.
Figure 22 - Show revisions
3.6.
Debug
This option will display the SW and HW revision info.The debug menu allows to easily use some of the debug
features implemented in the CoreTigo IO-Link wireless stack.
Figure 23 - Debug Menu
•
Show Analog Display -
When a W-Device is configured to analog mode, selecting this option will enter an
analog display mode, in which the analog value reported by the W-Device is displayed.
•
AL Read -
This Function allows ISDU Read from the Operational Wports.
Will return the value after entering the wanted port, index & subindex.
•
AL Write -
This Function allows ISDU write to Operational Wports.
Will write the value given entering the wanted port, index & subindex and Value.
•
Set PDOut -
This Function allows sending Process Data Out to selected operational Wport.
Used for Actuator mode.
•
Get PDIn
- This Function allows reading Process Data In from selected operational Wport. Used for
Sensor mode.
3.7.
Flash Internal MCU
This Function allows to flash the CT264-0083-01 STM32L151 MCU using the ST-Micro bootloader application
over UART. When this option is chosen and confirmed, the Nucleo-F767ZI will reset the STM32L151 on the W-
Master evaluation board and set the Boot0 pin to 1 and reset again, this action will cause the STM32L151 MCU to
boot with the bootloader application. The first action is then to initiate a communication over UART with the
bootloader application, then the STM32L151 Flash will be erased and rewritten with the image which can be found
in
Examples\IOLW_Basics_Example\Src
.
Once the flashing is done the W-Master application must be reset.
