ElectroLynx® is a registered trademark of ASSA ABLOY Inc.
Copyright © 2014 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
®
ASSA ABLOY
13
5) Installation of RF Technology Lock
Antenna
Circuit
Board
Oval Head Through-bolt
Mounting Posts
Retaining Tabs
The RF Technology Lock (M804, M805, M806) is installed as described in section 4 with the following
exceptions:
• Installation of the top through-bolt screw
• Removal procedure for the battery keeper
1. Installation of the top through-bolt screw:
The antenna board must be carefully moved to access the upper through-bolt screw. Care
should be taken to prevent damage to the antenna retaining tabs during this process.
Press the two tabs away from the antenna board and lift the board off the mounting posts.
Insert the oval head though-bolt and secure the escutcheon in place. After tightening the top
through-bolt, replace the antenna board by placing it on the mounting posts and pressing into
the retaining tabs.
2. Removal and Installation Procedure for Battery Keeper
To remove the battery keeper, a flat blade screwdriver or similar tool must be used. Insert screwdriver
into slot at top of battery keeper. Lift up and pull the top of the keeper away from the unit.
To install the battery keeper insert bottom tabs in bottom slots of controller, then press keeper over
batteries and snap into position.
C A U T I O N
DOOR MUST REMAIN OPEN
DURING INSTALLATION.
USE DOOR STOP.
TEST
FOR PROPER
OPERATION
BEFORE
CLOSING
DOOR
Battery Keeper
Bottom Slots
Screwdriver Slot
