ElectroLynx® is a registered trademark of ASSA ABLOY Inc.
Copyright © 2014 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
®
ASSA ABLOY
10
6
Installation of Inside Escutcheon (continued)
CAUTION: Do not allow lock body harness wires to enter cylinder hole in lock body. Wire
damage and/or malfunction of the lock may occur.
1. Turn inside lever to the horizontal position and rotate the thumb turn to the vertical position. Slide onto
spindle halfway. With inside escutcheon resting on spindle, be certain that all keypad ribbon cable will
remain inside ribbon cable hole, and that ground wire will not get pinched once escutcheon is
mounted. Escutcheon will not fit flush on door otherwise.
2. Insert 3 #10-24 screws through inside escutcheon and thread loosely into outside escutcheon. Check
operation of both inside and outside levers and make sure the thumb turn and key still operate the
latch and deadbolt correctly. If lock function is satisfactory, fully tighten the bottom two screws. Check
operation of both levers again. If levers move freely, tighten top screw. If levers do not move freely,
loosen bottom screws and realign the escutcheons until proper operation is obtained.
Inside
of door
Lock Body Harness - Feed excess
wire back into the mortise of the
door between the door cavity and
lock body. Do not feed excess
wires into the cylinder hole of
the lock.
4) Installation Instructions
