Menvier40/100
Installation
Page 27
this.
) See the installation instructions
supplied with each detector or
peripheral.
Note: When checking signal strength from
the User Menu the minimum acceptable
signal strength from a detector is four
units.
When checking the signal strength from the
Installer Menu the minimum acceptable
signal strength from a detector is two units.
Record the reading shown in the Installer
Menu for later inspection.
2. Install detectors and peripherals at their
selected locations.
3. Use the
Installer Menu – Test
(see
Chapter 5) option to:
a) carry out a walk test of the detectors.
b) test the operation of any other
peripherals.
Program the System
Program the system to suit user
requirements. Page 28 is a summary of the
Installer Menu on the control unit. Please
see the
Menvier40/100/300 Engineering
Guide
for a more detailed description.
Note: make sure that you allocate keypads
correctly to wards. For more information
see “Assigning Wired Keypads to Wards” in
the
Menvier40/100/300 Engineering Guide
.
Assemble and close the control unit:
a) Fit the lid of the control unit into the
back of the case (see Fig 39).
b) Fit and tighten the lid fixing screw.
NOTE: It is possible, for convenience, to
place links over tamper contacts to inhibit
tamper alarm during installation. Because
of this feature make sure you test all lid
tampers before completing installations, to
ensure that no links are left fitted.
Figure 39 Replacing the control unit lid.
Leave the Installer Menu.
The red LEDs should go out, and the rim
of the navigation keys glow green. The
system is now ready to hand over to the
user.
Handover to the User
Instruct the user on how to operate the
system. See the
Menvier40/100/300
Administrator’s Guide
. If necessary, show
them how to set the time and date on the
system.
Remember to leave the
Menvier40/100/300
Administrator’s Guide
with the user.
Содержание Menvier 100
Страница 1: ...MENVIER SECURITY...
Страница 4: ...Menvier40 100 Page iv This page is intentionally blank...