Cooper Menvier Menvier 9651, Руководство пользователя

Страница: 6 / 28

Page 6 496930
2. Everyday Operation
There are several different ways of setting the system. For all methods
(except using a
keyswitch ) you must enter your access code or present a
tag at the keypad. The keyswitch method uses a key in a special switch fitted
to your premises. "Setting the System" below describes each method. Ask
your Installer to provide the method that suits your site best.
During installation the Installer programs the system to create an exit route
for your premises. When setting the system you must follow this route to
leave the premises. You must also follow a specified
entry route when
going into the premises in order to unset the system. If you stray from these
routes you may cause a false alarm.
How Do I Know if the System is Working?
The
a
lamp always glows when the mains power is present. If the
a
lamp
flashes slowly then mains power is off, and the system is working from its
internal battery. If the
a
lamp is off then the system is dead.
When the system is set, the keypad display shows which Level is set.
However , the Installer can program the system to hide this display. Ask your
Installer how the system is set up.
If you wish to test the system and its detectors, see "4. Special Functions -
Testing the System" on page 27.
Setting the System
Your alarm system provides several different methods for setting:
Timed Set.
Final Door Set.
Exit Terminate Button.
Part Setting (including Instant Set or Silent Set).
Keyswitch Setting.
Lock Set.
Ask your Installer which method is fitted, and then use the following pages
for detailed instructions.