Cooper Menvier Menvier 9651, Руководство пользователя

Страница: 27 / 28

3. After an Alarm
496930 Page 27
Testing the System
Bell Test
You can test that all the sounders and the strobe are working, as follows:
1. Key in your access code. or present a tag
2. Press 8.
The system turns the external sounder, internal sounder(s) and
keypad sounders on for three seconds each, one after the other.
The strobe flashes for six seconds to give you time to see it.
Walk Test
You can set the system so that it will allow you to walk round the premises
and test each of the detectors (a
walk test ). Choose a time when the
premises are empty to carry out the test, otherwise people may trigger any
movement detectors before you do, and confuse the results of the test.
If any detector fails the test then call your alarm company and ask them to
check the system.
Note: If your system is fitted with 24 hour or personal attack detectors, you cannot
walk test them. If you wish to test them call your alarm company.
1. Key in your access code. or present a tag
2. Press 9.
This display shows:
3. Walk round your premises and trigger each detector in turn
(except 24 hour or personal attack detectors).
As you trigger a detector the keypad and
internal sounder give a short tone. The
display shows the zone number of any
detector(s) that you have triggered. If
there is more than one detector triggered
then the display show the number of each
detector in turn.
4. Press
Y
to stop the test when you have triggered
all the detectors.
Note:
1. You can abandon the test at any time by pressing
Y
.
2. You cannot test Fire, PA or other types of 24 hour zone with this command.
3. You cannot test tamper circuits with this command.
Walk Test
A: Zone 02